Carefully tuck the wires into the box, leaving room for the switch.

Consider recording the marking/color coding of the Traveler-1 (5) and Traveler-2 (7) wires so you can tell them apart for later use.

Connect the other end of the jumper wire (6) back to the common terminal (C) on the switch.

You should have three wires connected with one wire nut.

Using Figure 4 as a visual reference, connect the jumper wire (6) (supplied), the LINE wire (1) from the common terminal (C), and the Traveler-2 wire (7) together.

Using the LINE Side of Figure 3 as a visual reference, label and remove the LINE wire (1) from the common terminal (C) and the Traveler-2 wire (7) from the HOT terminal (H).

Disconnect the power from the circuit by turning off the circuit breaker or removing the fuse from the fuse box.

Timer on LOAD side 3-way installation instructions Remount the timer and wallplate, then restore power at the fuse box or circuit breaker. Swap the LINE and LOAD wires on the timer.

If the timer does not turn on, disconnect the power at the circuit breaker or fuse box.

Turn the main power on at the circuit breaker.

Use the screws to mount the timer to the wall box, being careful not to crush any wires.

Ensure that all terminals are tightened to between 8.85 and 12.39 lbf-in., and tuck the wires into the wall box, leaving room for the timer.

Add the timer Neutral wire to the other neutral wires, bound together making sure the wire nut is tight. There may be several neutral wires bound together. Often the Neutral wire can be found in the back of the wire box connected with a wire nut.

Connect the timer to the wall box wires as shown in Figure 2.Ī) Connect the hot/live LINE wire to the LINE terminal of the timer.ī) Connect the hot/live LOAD wire to the LOAD terminal of the timer.Ĭ) Connect the Ground wire to the GROUND terminal of the timer.ĭ) Connect the Neutral wire to the NEUTRAL terminal of the timer.

Turn OFF the main power at the circuit breaker or fuse box.

NOTE: If you are unsure or unclear about this installation or if the wires in your box do not match the manual (not all switch boxes have neutral wires), contact a qualified, licensed electrician. Place the new faceplate into position and carefully push the bottom of the faceplacte until it snaps into place. Find the light almond faceplate in the package.

Work around the faceplate until it pops off. Find the slots at the bottom left or right of the white faceplate and pry the faceplate loose (see Figure 1).

Gently remove the white faceplate using a flat head screwdriver.

To switch faceplates, proceed as follows: This device includes a light almond faceplate.

FOR GROUNDING LEAD, USE 12 AWG OR LARGER WIRE RATED AT LEAST 75☌.FOR SUPPLY CONNECTIONS, USE 14 AWG OR LARGER WIRE RATED AT LEAST 75☌.DO NOT USE TO CONTROL APPLIANCES THAT CONTAIN HEATING ELEMENTS (COOKING APPLIANCES, HEATERS, IRONS, ETC.).Owner's Guide Tools Home Improvement Installation Instructions GE ‎32787 7-Day Programmable Indoor/Outdoor In-Wall Digital Timer - Use Manual - Use Guide PDF.

Ge sunsmart digital timer